V-R200 Installation Manual
– 1 –
I. Before Installation
1. Precautions
• Do not place in unstable locations such as on an unsteady table or an inclined location. It could fall
and cause injury.
• Do not place in a location with high humidity or dust. This may result in fi re or electrical shock.
• Do not place in a location exposed to oil smoke or humidity such as close to cooking table or
humidifi er. This may result in fi re or electrical shock.
• Do not place in a location close to heating devices such as a stove or a heater, or location directly
exposed to hot air. This may result in fi re.
• Use only the designated power supply for the AC adaptor, and fully insert the power plug of the AC
adaptor into the outlet.
• Select the outlet where the power cord of this product is easily reached, and plug/unplug of the
power plug can easily be performed.
• Do not pinch the power cord between objects such as products, walls, and shelves. Also, do not
put heavy objects on the power cord.
• Do not coil or bundle the power cord.
• When moving the product, fi rst return the main display to the original position. Next, perform the
shutdown operation, and then pull out the power plug from the outlet. For the shutdown operation,
refer to “IV. Information - 1. Basic Operation - (2) Shutdown procedure (P.21)”.
Fig. 1
TILT
DOWN UP
To Next Page
Loading...
Need help?
General
