CBN CH6643E - Getting Started with CH6643 E Setup

Inside the Box
Before you install the
are included in the box with the
Item
Power cord
Software License &
Regulatory Card
CH6643
E Install
Sheet
You must have the latest service packs and patches installed on your computer for
your operating system.
You will
need a 75
CH6643
E to the nearest cable outlet. If a TV is connected to the cable outl
may need a 5 to 900 MHz RF splitter and two additional coaxial cables to use the
TV and the
CH6643
Before You Begin
Take the following precautions before installing the
•
Postpone installation until there is no risk of thunderstorm or ligh
the area.
•
To avoid potential shock, always unplug the power cord from the wall outlet
or other power source before disconnecting it from the
•
To prevent overheating the
the
sides of the unit. Do not open the unit. Refer all service to your Internet
Service provider.
Check that you have the required cables, adapters, and adapter software.
that the proper drivers are installed for the Ethernet adapter on each networked
computer.
For information on WLAN setup, see
2. Getting Started
Before you install the
CH6643
E Wireless Gateway, verify that the following items
are included in the box with the
CH6643E:
Item
Description
Connects the
CH6643
electrical outlet
Software License &
Contains software license, warranty, and
safety information for the
E Install
Provides basic information for setting up
the CH6643E
You must have the latest service packs and patches installed on your computer for
your operating system.
need a 75
-ohm coaxial cable with F-
type connectors to connect the
E to the nearest cable outlet. If a TV is connected to the cable outl
may need a 5 to 900 MHz RF splitter and two additional coaxial cables to use the
CH6643
E.
Take the following precautions before installing the
CH6643E:
Postpone installation until there is no risk of thunderstorm or ligh
To avoid potential shock, always unplug the power cord from the wall outlet
or other power source before disconnecting it from the
CH6643
To prevent overheating the
CH6643
E, do not block the ventilation holes on
sides of the unit. Do not open the unit. Refer all service to your Internet
Service provider.
Check that you have the required cables, adapters, and adapter software.
that the proper drivers are installed for the Ethernet adapter on each networked
For information on WLAN setup, see
Setting Up Your Wireless LAN
11
E Wireless Gateway, verify that the following items
Description
CH6643
E to an AC
Contains software license, warranty, and
safety information for the
CH6643E.
Provides basic information for setting up
You must have the latest service packs and patches installed on your computer for
type connectors to connect the
E to the nearest cable outlet. If a TV is connected to the cable outl
et, you
may need a 5 to 900 MHz RF splitter and two additional coaxial cables to use the
Postpone installation until there is no risk of thunderstorm or ligh
tning activity in
To avoid potential shock, always unplug the power cord from the wall outlet
CH6643
E rear panel.
E, do not block the ventilation holes on
sides of the unit. Do not open the unit. Refer all service to your Internet
Check that you have the required cables, adapters, and adapter software.
Verify
that the proper drivers are installed for the Ethernet adapter on each networked
Setting Up Your Wireless LAN
.