- 16 -
System
Version Program version, read only
Serial Circuit board S/N, read only
Box temp Internal box temperature, read only
Box heat Indication of heat ON / OFF, read only
Fieldbus Press “ENTER” to see the Fieldbus status sub menu
Correct type Yes or no, read only
Installed Yes or no, read only
Hardwarefail Yes or no, read only
Initialised Yes or no, read only
Online Yes or no, read only
Software v. Software version of the Fieldbus module, read only
Outdata Last data sent to master, read only
Err Cmd Last error, read only
Err Cmd 1 Last error, read only
Test Press “ENTER” to go to the system test sub menu
Relay1 Off / On, be careful if something is connected to the relay
Relay2 Off / On, be careful if something is connected to the relay
Analog 1 mA Current of analog output 1, read only
Analog 2 mA Current of analog output 2, read only
Panel LED Green / Red
Box heat Off / On, read only
Ø There may or may not be an additional Cerlic internal
submenu that is not documented, and that may change
without notice.
Empty Slot
slot 1 Forget the previously installed transmitter in slot 1
slot 2 Forget the previously installed transmitter in slot 2
slot 3 Forget the previously installed transmitter in slot 3
slot 4 Forget the previously installed transmitter in slot 4
To Next Page
Loading...