5.4.2 Fitting ILS-I internal door handle set to rosette holes
These instructions show the mounting to rosette holes. The long shield is fitted following the same
procedure.
Tools required
Tool Version Use
3mm Allen
key
For the countersunk head screws of the outside shield
Cross-head screwdriver
PH1/PH2
For fixing the countersunk head screws into threaded
bolts M4/M5
Page 20 of 83 Wide shield replacement handle set ILS-I
5.4 ILS-I assembly
Overview: Use of master media Help & troubleshooting Technical data Maintenance & disposal
Operation
Administration Assembly Basic information
To Next Page
Loading...
