Mounting on the outside of the door
1. Insert the THREADED BOLTS as per the previously fitted
handle set (here: rosette handle set).
2. Adjust the position of the THREADED BOLTS to the hole
pattern.
3. Insert the SQUARE SPINDLE into the COUPLING FOLLOWER.
Ensure that the elongated hole is in a horizontal
position.
Ensure that the SQUARE SPINDLE snaps in to the
coupling follower.
Page 22 of 83 Wide shield replacement handle set ILS-I
5.4 ILS-I assembly
Overview: Use of master media Help & troubleshooting Technical data Maintenance & disposal
Operation
Administration Assembly Basic information
To Next Page
Loading...
