System error
If system errors occur, they are signalled after the following actions:
l
After reading authorised locking media
l
After an attempt to put a handle set into release mode or emergency mode
l
After the start sequence (insertion/connection of batteries)
Signal Cause Solution
3x short red
2x long red
System error: The actuator of the locking device is
not working correctly.
Check whether the actuator has jammed.
If you cannot resolve the error yourself,
contact your CEStronics partner.
Wide shield replacement handle set ILS-I Page 53 of 83
9.2 Loss of a locking medium
Overview: Use of master media
Help & troubleshooting
Technical data
Maintenance & disposal Operation Administration Assembly Basic information
To Next Page
Loading...
