11.7.2 Deactivating block mode
Required:
l
Block-Master (must be authorised for the locking device beforehand)
Procedure:
Steps Signal
3. Hold the Block-Master in the reading field of the locking device.
Block mode is deactivated. 2x short green
4. Remove the Block-Master from the reading field of the locking device.
Block mode is now deactivated. Access is now possible again with authorised locking
media.
Troubleshooting:
Signal Cause Solution
1x long red An opening mode with higher priority is currently act-
ive.
Deactivate the
opening mode with the higher pri-
ority.
The Block-Master is not authorised. Authorise the
Block-Master.
Wide shield replacement handle set ILS-I Page 71 of 83
11.7 Block mode
Overview: Use of master media
Help & troubleshooting
Technical data
Maintenance & disposal Operation Administration Assembly Basic information
To Next Page
Loading...
