11.8.2 Deactivating emergency mode
Required:
l
Emergency-Key (must be authorised for the locking device beforehand)
Procedure:
Steps Signal
1. Hold the Emergency-Key in the reading field of the locking device that is in
emergency mode.
Emergency mode is deactivated. 2x short green
2. Remove the Emergency-Key from the reading field of the locking device.
Emergency mode is now deactivated.
Troubleshooting:
Signal Cause Solution
1x long red The Emergency-Key could be read but is not authorised for this
locking device.
Authorise the
Emergency-Key.
Wide shield replacement handle set ILS-I Page 73 of 83
11.8 Emergency mode
Overview: Use of master media
Help & troubleshooting
Technical data
Maintenance & disposal Operation Administration Assembly Basic information
To Next Page
Loading...
