Steps Signal
1. Take your PC and the connected RF-Stick to the locking device to which you wish to
transmit programming jobs.
If you need to transmit programming jobs to multiple locking devices, you can
freely select the order in which you visit them.
2. Hold the RF-Stick-Master briefly in the reading field of the locking device.
The RF-Stick-Master is accepted. 1x short green
3. The locking device now searches for an RF-Stick in its vicinity. Transmission begins once
the RF-Stick is detected.
The distance between the locking device and RF-Stick must not exceed ten metres.
Programming jobs are being transmitted. Short green signals
The following occurs during transmission:
- All programming jobs for this locking device are transmitted to the locking device. During
the programming process, the programming status display indicates the progress as a
percentage.
- All events stored in this locking device that are not yet present in the OMEGA Client are
copied to the OMEGA Client.
- The clock is set.
If no programming jobs are present, only the events are copied and the clock is set.
In this case the locking device does not flash during transmission.
4. After the transmission, the RF-Stick and locking device are disconnected automatically.
Transmission was completed successfully. 1x long green + beep
After transmission is complete, the programming job is removed from the ‘Programming
status’ list.
Troubleshooting:
Signal Cause Solution
After step 2:
1x long red + beep The locking device cannot
detect an RF-Stick in the
vicinity.
Check that the RF-Stick is properly connected and take it closer
to the locking device, then try to transmit the programming
jobs again.
Wide shield replacement handle set ILS-I Page 79 of 83
11.11 Transmitting programming jobs to a locking device using an RF-
Stick
Overview: Use of master media
Help & troubleshooting
Technical data
Maintenance & disposal Operation Administration Assembly Basic information
To Next Page
Loading...
