8.6
Compressor case
8.7
Compressor case
Rear cover and compressor case
Starter and protector of the compressor
1）Cut off the power, remove the goods in the
refrigerator, with the tape to make the door fixed firmly
and prevent the door dropping when the refrigerator
dumping.
2）Slowly tilt the refrigerator forward, relying on the wall
or a solid enough object, leaving space to facilitate the
operation. For safety, it should be carried by someone
to prevent its falling.
3）Cut off the compressor pipeline.-Cut off the process
pipeline.-Cut off the low-pressure muffler.-Cut off the
high-pressure exhaust pipe.
4）Remove the screws
-Two screws outside
-One screw inside
5）Remove the clipping strip
Slowly pull it out
To Next Page
Loading...