Chattanooga Intelect RPW 2 - Spine and Fasciae Shock Transmitters

79
CLEANING, MAINTENANCE, OVERHAUL
EN
INTELECT
®
RPW 2 USER MANUAL
SPINE AND FASCIAE SHOCK
TRANSMITTERS
. Disconnect the handpiece from the control device.
The spine or fasciae transmitter set contents a special clutch
for mounting the spine or fasciae transmitters. The shock
transmitter can only be mounted if the clutch has already
been screwed on the handpiece.
. Screw the clutch onto the handpiece.
. Take out the desired shock transmitter from the case.
. Push the inner part of the clutch in direction to the shaft
of the handpiece ().
• Push the shock transmitter into the clutch ().
. Release the inner part of the clutch.
• The shock transmitter engages into its place.
Note: Before starting with treatment make sure that the shock
transmitter is engaged into its place.
. To disassemble the shock transmitter proceed as follows:
• Push the inner part of the clutch in direction to the
shaft of the handpiece
• Pull the shock transmitter out of the clutch.