Chattanooga Intelect RPW 2 - Electromagnetic Emissions Declaration; Electromagnetic Immunity Declaration

92
APPENDIX
EN
INTELECT
®
RPW 2 USER MANUAL
ELECTROMAGNETIC COMPATIBILITY (EMC) TABLES (CONTINUED)
12.2 Electromagnetic immunity : Guidance and Manufacturer’s Declaration - Electromagnetic Immunity
Intelect RPW  is intended for use in the electromagnetic environment specified below. It is the responsibility of the customer or user to ensure
that the Intelect RPW  device is used in such an environment.
Immunity Test IEC 60601 Test Level Compliance Level Electromagnetic Environment - Guidance
Electrostatic
discharge (ESD) to
IEC --
±  kV contact
±  kV air
±  kV contact
±  kV air
Floors should be wood, concrete or ceramic tile. If floors are covered with
synthetic material, the relative humidity should be at least %.
Electrical fast transient/
bursts to
IEC --
±  kV
 kHz repetition
frequency
±  kV
 kHz repetition
frequency
Mains power should be that of a typical commercial or hospital environment.
Surges to
IEC --
± kV Line to Line
± kV Line to Earth
± kV Line to Line
± kV Line to Earth
Mains power should be that of a typical commercial or hospital environment.
Voltage dips
To IEC --
% UT ; , cycle at °, °, °, °,
°, °, °, °
% UT ;  cycle and
% UT ; / cycles
Single phase at °
% UT ; , cycle at °, °, °, °,
°, °, °, °
% UT ;  cycle and
% UT ; / cycles
Single phase at °
Mains power should be that of a typical commercial or hospital environment.
If the user of the Intelect RPW  device requires continued operation during
power mains interruptions, it is recommended that the Intelect RPW  device be
powered from an uninterruptible power supply or a battery.
Power frequency
(/ Hz)
magnetic field to
IEC --
 A/m  A/m
Power frequency magnetic fields should be at levels characteristics of a typical
location in a typical commercial or hospital environment.
Note: UT is the a.c. mains voltage prior to application of the test level.
12.1 Electromagnetic emissions: Guidance and Manufacturer’s Declaration – Electromagnetic Emissions
Intelect RPW  is intended for use in the electromagnetic environment specified below. It is the responsibility of the customer or user to ensure
that the Intelect RPW  device is used in such an environment.
Emissions Tests Compliance Electromagnetic Environment - Guidance
RF emissions CISPR  Group 
Intelect
®
RPW  uses RF energy for its internal function.
Additionally the Intelect RPW  contains a Bluetooth
®
radio module, which complies with the national
regulations. Therefore, its RF emissions are very low
and are not likely to cause any interference in nearby
electronic equipment. However, a separation distance
of  cm shall be maintained.
RF emissions to CISPR  Class B
Intelect RPW  is suitable for use in all establishments,
other than domestic and those directly connected to
the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Harmonic emissions to
IEC --
complies with class
A requirements
Voltage fluctuations/flicker
emissions to IEC --
complies