Chery A11 2003 - Page 540

CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual
4. Press the clutch’s outer racer on the one-way overrun clutch drum;
ool of KA-000-232 (bearing remover);
6.
aft
Connect the output shaft with
the gear ring;
Install the snap ring on the output
shaft;
Install the output ring and
one-way overrun clutch into the
housing;
Install the assembled
transmission on the vehicle.
D
S
rem
Remove the automatic
5. Install the snap ring and retaining ring with the special t
Press fit the tapered roller
bearing on the output sh
with the special tool of
KA-000-300.
7.
8.
9.
10.
riven shaft and governor
pecial tool: KA-000-232 bearing
over
isassembly procedure: D
1.
108