[DB600] General Instruction Manual
- 1 -
Introduction
Thank you for purchasing Digital Indicating Controller [DB 600 series].
Understand the instrument properly and read this instruction manual beforehand in order to avoid any
troubles.
For specification regarding communications interfaces, read [Communications interfaces instruction
manual] along with this manual.
About DB600
① DB600 (with programming function) is a digital programming controller which is able to store
maximum 4 patterns by 12 steps programming operations.
② SV, PID and event value are able to be registered at 8 types of execution No.
③ High accuracy of measured accuracy ± 0.1 % and control interval 0.1 sec.
④ Display measured value (PV)/setting value (SV) and analog bar of output value by high view
angle/brightness provided by LCD.
This instrument is warranted for one year from the date of delivery. If it is damaged during the
warranty period, when used normally based on the cautions in the instruction manual, labels, and
markings attached to the instrument, etc., it will be repaired without any charge (only in Japan). In
the case, we are sorry to trouble you, but please contact your dealer or nearest our sales office.
However, in cases of the followings, it will be repaired at your expense even during warranty period.
1. Failure or damage caused by improper use or connection, or invalid repair or modification.
2. Failure or damage caused by fire, earthquake, wind or flood, thunderbolt, or other extraordinary
natural phenomena, or pollution, salt, harmful gas, abnormal voltage, or use of unspecified
power.
3. Replacement of parts or accessories that have reached the end of their life.
Furthermore, the term ‘warranty’ in this sense covers only a CHINO’s product itself. Therefore, we
are not responsible for compensation for whatever the damage that is triggered by failure of our
product.
1. No part of this manual can be reproduced or copied in any form without permission.
2. The contents of this manual may be altered without prior notice.
3. This manual has been documented by making assurance doubly sure. However, if any question
arises or if any error, an omission, or other deficiencies are found, please contact your nearest
our sales office.
4. CHINO is not responsible for any operation results of this instrument.
Other described company names and product names are trademarks and registered products of
the respective companies.
Please note that the marks “TM ”and “®”are omitted throughout this manual.
To Next Page
Loading...
Need help?
General
