ChipBLASTER Inc
47
20.0. ELECTRICAL DRAWINGS (Cont.):
CONTROL PLUG (9PIN)
OPTIONAL USE WITH MACHINE TOOL SPECIFIC INTERFACE
NOTE:
1. CR1 & CR3 COIL VOLTAGE IS DEPENDENT
ON THE MACHINE TOOL OUTPUT
VOLTAGE.
2. SPARE CABLE WIRES: GRAY, BROWN,
PINK,
ORANGE, YELLOW, WHITE, WHITE/GREEN.
3. 12 PIN COMPONENTS
P/N 5810 (1) INSERT
P/N 5808 (1) HOUSING
4. 9 PIN COMPONENTS
P/N 5146 (1) RECEPTACLE
P/N 5149 (1) CAP
P/N 5150 (9) CRIMP PINS
P/N 0560 (1) O-RING
5. TO USE THE LOW PRESSURE OPTION
CONNECT CONTROL VOLTAGE AS
REQUIRED TO PIN9 ON 12 PIN PLUG
OR PIN 5 ON 9 PIN PLUG. THEN CONNECT
COM 31 TO COM1 OR COM3 DEPENDING
ON VOLTAGE USED.
Chip
THIS PRINT IS THE PROPERTY OF ChipBLASTER. THIS
DOCUMENT CONTAINS PROPRIETARY INFORMATION AND SUCH
INFORMATION MAY NOT BE DISCLOSED TO OTHERS FOR ANY
PURPOSE OR USED FOR MANUFACTURING PURPOSES WITHOUT
WRITTEN PERMISSION FROM ChipBLASTER.
Tolerances
0.0005
0.01
0.005
1/32
BREAK ALL SHARP EDGES
(NONACCUMULATIVE)
X.XX
REMOVE ALL BURRS &
X.X
BLASTER
X.XXXX
X.XXX
Chip
UNIT:SIZE:
C
QTY.
CUSTOMER:
APPROVED BY:
FAX: (814)724-6287
PHONE: (814)724-6278
BLASTER
www.chipblaster.com
DRAWN BY: DATE:
TITLE:
IT.
DRAWING NUMBER:
OF
SHEET: REV:
MAT'L:
PART No.
REV
DESCRIPTION
DATE
SCALE:
NOTES
DESCRIPTION
13605 S. MOSIERTOWN ROAD
MEADVILLE, PA 16335
USA
NAME
AND POWER INTERFACE
D30-80-1 STANDARD CONTROL
JRG
JRG
21JUN07
D30L-003
33 A
NTS
N.O. ERROR SIGNAL
(READY SIGNAL)
CLOSED = OKAY
11
GND (PE)
ERROR SIGNAL
(READY SIGNAL)
COMMON
N.O. ERROR SIGNAL
(READY SIGNAL)
CLOSED = OKAY
N.C. ERROR SIGNAL
(READY SIGNAL)
OPEN = OKAY
GND (PE)
LOW PRESSURE
OPTION
9
8
7
5
6
COMMON
COOLANT #1 ON
COMMON
N.C. ERROR SIGNAL
(READY SIGNAL)
OPEN = OKAY
1
INDEX
3
4
2
12
ES
ES
CR31
3 PHASE SUPPLY INPUT
REFER TO POWER
WIRING FOR
CURRENT DRAW.
CR3
CR1
GND (PE)
1DS
COMMON
8
LOW PRESSURE
COOLANT
ERROR SIGNAL
(READY SIGNAL)
COMMON
10
9
3 PHASE SUPPLY
COOLANT #1 ON
INDEX
COMMON
6
7
5
GND (PE)
L1
L2
L3
4
3
1
2
STANDARD POWER INTERFACE PLUG (12 PIN)
ChipBLASTER MACHINING CENTER
20.0
To Next Page
Loading...