ChipBLASTER STANDARD UNIT D30-80-1 - Table of Contents

ChipBLASTER Inc
6
2.0. Table of Contents:
General (Standard Unit) Page 3
General (CE Certified Unit) Page 4
General warnings Section 1.0 Page 5
Table of contents Section 2.0 Page 6
Specifications Section 3.0 Page 8
Safety precautions Section 4.0 Page 9
Explanation of markings Section 4.1 Page 9
Storage Section 5.0 Page 14
Moving machine Section 6.0 Page 14
Placing a ChipBLASTER Section 7.0 Page 15
Mechanical installation Section 8.0 Page 16
Electrical installation Section 9.0 Page 17
Power Interface Section 9.1 Page 17
Control Interface Section 9.2 Page 17
Start up Section 10.0 Page 18
Air Purge Procedure Section 11.0 Page 19
Operation Section 12.0 Page 20
Electrical operation Section 12.1 Page 20
Coolant flow Section 12.2 Page 20
Coolant flow Diagram (Figure 1) Section 12.2 Page 21
Alarms Section 13.0 Page 22
Preventive maintenance Section 14.0 Page 22
Schedule (Figure 2) Section 14.1 Page 23
High pressure pump – Check oil - Dipstick Section 14.2 Page 24
High pressure pump – Check oil – Sight gauge
Section 14.2 Page 25
High-pressure pump –
Oil change procedure Section 14.3 Page 26
High pressure pump – Check belt Section 14.4 Page 29
High-pressure pump – Check for leaks Section 14.5 Page 29
High-pressure pump – Rebuild Section 14.6 Page 29
Return (Transfer) Pump – Check for leaks Section 14.9 Page 29
Cartridge filter – Check pressure gauge Section 14.12 Page 29
Filter change procedure – General Warnings Section 14.13 Page 30
Dual manual change filter (shutdown) Section 14.14 Page 30
Dual manual change filter (operating) Section 14.15 Page 31
Filter Replacement form
Section 14.16 Page 32
Filter assemblies – Check for leaks Section 14.17 Page 33
Filter assemblies – Cleaning Section 14.18 Page 33
Pump mounting bolts – Check Section 14.27 Page 33
Return pump - Check flow rate Section 14.29 Page 33