EasyManuals Logo

Chris-Craft 32 Launch (RJ) User Manual

Chris-Craft 32 Launch (RJ)
234 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #101 background imageLoading...
Page #101 background image
It is illegal to discharge oily bilge water into the waters of the United States.
Bilge oil spills must be mopped up and the oil and rags properly disposed of.
Bilge Pumps (Continued)
If oil is present in the bilge, do not use the bilge pump to discharge the waste.
Mop up the waste and dispose of properly.
The two (2) bilge pumps in the RJ/RK are located in the Engine Room as shown here.
Should a bilge pump fail to operate, check the breakers and wiring connections. If the pump operates
but fails to discharge water, inspect for clogs or kinks in the discharge line.
Do not run a bilge pump for an extended period of time in a dry environment. Damage
and/or premature wear to the pump may result.
3-39 3-39
Systems
NOTICE
NOTICE
Figure 3-69. 1000 GPH Bilge Pump (2) Each
Figure 3-70. Water Pump Float Switch (2) Each
Figure 3-68. Engine Room Bilge Pump
The Engine Room
Bilge Pump Is
Located On the
Starboard Side Of
The Center Stringer
Figure 3-67. High Water Bilge Pump
The High Water Bilge
Pump Is Located On the
Port Side Of The Center
Stringer

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Chris-Craft 32 Launch (RJ) and is the answer not in the manual?

Chris-Craft 32 Launch (RJ) Specifications

General IconGeneral
BrandChris-Craft
Model32 Launch (RJ)
CategoryBoat
LanguageEnglish

Related product manuals