3-54 3-54
Marine Sanitation System - RJ Models
Waste in the holding tank can form methane, an explosive gas.
Keep vent open and clear of obstructions. Keep fire and flame
away when maintaining the system.
It is illegal to dump plastic trash anywhere in the ocean or navigable
waters of the United States, including the Great Lakes. The discharge
of other types of garbage is permitted outside of specific distance
offshore as determined by the nature of that garbage.
All recreational boats with installed toilet facilities must have an
operable Marine Sanitation Device (MSD) aboard. Vessels 65 feet and
under may use a Type I, II, or III MSD. All installed MSD's must be
Coast Guard certified. The Holding Tank installed in the Chris-Craft is
certified by definition under the regulations and is not specifically
labeled. Do not flush foreign objects down the MSD. Damage to the
system may result.
A Tecma system is installed in the RJ and RK models. The Marine Toilet Owner’s Manual that comes in
the documentation package addresses the use, maintenance, and troubleshooting of the waste system.
It is your responsibility to become familiar with its contents.
Tecma units utilize a grinding system that grinds all waste before it enters the pump. This system virtu-
ally eliminates clogging while consuming very little water. To use, press the “Add Water” button to send
a specific quantity of water into the bowl. Press the “Flush” button to begin the automatic flushing cycle.
This leaves the water closet clean and dry. The cycle is completely automatic and works on a 12/24
VDC electrical system.
Figure 3-102.
RJ Tecma Toilet System
Systems
RJ Installation Port Side
To Next Page
Loading...
Need help?
General
