Marine Sanitation Device
_______ Prepare in accordance with manufacturer’s directions.
General
_______ Clean all sections of the boat as necessary.
_______ Inspect all thru-hull openings. Ensure they are clean and open.
_______ Check running gear. Replace propellers if removed.
_______ Check all life saving gear. Replace as necessary.
_______ Cycle all seacocks and valves to ensure proper and free movement.
_______ Leave open appropriate valves.
_______ Check hoses and clamps.
_______ Re-install all drain plugs.
_______ Inspect the electrical system completely.
_______ Inspect navigation lights and check for proper operation.
_______ Check all switches for proper operation.
_______ Ensure engine compartment blower is operating properly.
_______ Ensure blower exhaust vents are not obstructed.
_______ Inspect, and if necessary replace, anchor lines and gear.
Fuel System
_______ Thoroughly check each fitting and hose in the fuel system. Ensure it is fuel and vapor tight.
_______ Open any valves closed for winterization.
Engines
_______ Refer to the engine’s manual for detailed recommissioning instructions.
_______ Ensure fluids are at proper levels.
Batteries
_______ Ensure batteries are clean and corrosion-free before installing.
_______ Ensure batteries are properly secured in their mounts.
Fresh Water Systems
_______ Connect any water lines that may have been removed or disconnected.
_______ Energize pressure pump and check for leaks.
_______ Sanitize the system. Flush the system completely. If necessary drain and re-flush. Ensure all
contaminants are removed from the system.
_______ Bleed all air from the system.
_______ Close all faucets as required.
Spring Commissioning
4-4 4-4
Storage And Commissioning
To Next Page
Loading...
Need help?
General
