Freeze-dryer Alpha 1-4 LSCplus
Freeze-dryer Alpha 2-4 LSCplus
Version 01/2011, Rev. 2.3 of 03/07/2017 • sb
Translation of the original operating manual
Dialog box "Schematic system diagram ..... 44
Dialog box "Tools" ...................................... 42
Dimensions ................................................ 94
Dimensions and weight .............................. 28
Direct hazard to the life and health ............. 21
Disinfectants .............................................. 89
Disinfection of the drying chamber and
accessories ............................................ 89
Displayed vacuum value is not correct ....... 80
Disposal of the freeze-dryer ....................... 92
Disposal of the packaging .......................... 92
Double-chamber method .......................... 126
Double-chamber method (outside) ............. 51
Double-chamber method LyoCube (outside)
............................................................... 51
E
Earth conductor check ............................... 26
EC declaration of conformity (Machinery
Directive) ........................................ 10, 103
Editing a program....................................... 74
Electrical connection .................................. 94
Electrical connection of the vacuum sensor
......................................................... 13, 99
Electrical safety .......................................... 24
EMC according to EN 55011 ...................... 94
Emissions .................................................. 25
End of drying and aeration ......................... 19
Entering set values in the manual mode .... 63
Equipment connections .............................. 94
Equipotential bonding screw .......... 13, 26, 99
Error correction .......................................... 79
Error messages ......................................... 26
Eutectic point ........................................... 125
Exhaust filter ........................................ 35, 88
Explanation of symbols .............................. 10
Explanation of the symbols and notes ........ 21
External data storage device ...................... 41
F
Failure memory .......................................... 58
Filling quantity ............................................ 94
Final drying ................................................ 19
Fire prevention ........................................... 25
Form for the return of defective parts ......... 91
Freeze-dryer type ....................................... 62
Freeze-dryer, cleaning and care ................ 86
Freeze-drying phases ................................ 16
Freeze-drying process ......................... 17, 51
Freeze-drying with the PGMplus programmer
module ................................................... 65
Freezing ..................................................... 17
Functional and operating elements ............ 11
Fuses ......................................................... 25
G
General conditions ....................................... 9
General information on freeze-drying ......... 14
General malfunctions ................................. 79
General work (maintenance) ...................... 85
H
Hazard warnings .......................................... 9
Heat emission ............................................ 94
Heat exchanger ......................................... 87
Heat exchanger of the refrigeration unit 13, 99
Highly corrosive substances ...................... 24
Hot-gas defrosting ...................................... 19
I
Ice condenser ............................................ 93
Ice condenser chamber........................ 11, 97
Ice condenser chamber, cleaning and care 86
Ice condenser temperature ........................ 67
Importance of the operating manual ............. 9
Important information ................................. 21
Infectious substances .......................... 25, 89
Inflammable substances ............................ 25
Informal safety instructions ........................ 23
Initial start-up ............................................. 38
Inspection by the manufacturer .................. 90
Installation of accessories .......................... 38
Installation site ........................................... 31
Insufficient ice condenser or shelf
temperature ............................................ 80
Insufficient ice condenser temperature ....... 83
Insufficient vacuum .............................. 79, 81
Intended use ................................................ 9
IP protection category according to DIN
60529 ..................................................... 94
L
Language ................................................... 50
Layout of the freeze-dryer .......................... 11
Leakage in a rubber valve .......................... 79
To Next Page
Loading...
