xii
Add “Material Contents Declaration”
Delete the description of Disposal in “Storage, Freight, Maintenance
& Disposal”
- the column of Part Number in the section of “Standard
Accessory” & “Optional Accessory”.
- the description of “I-RUS” in the section of “PROGRAM
Parameter Setting”.
- the description of “Inrush” in DC Mode table in the section of
- the description of “Hipot” item in the section of “Specifications”.
- the description of table in the section of “Standard Accessory”.
- “(3) System Parameter Setting Table” in the section of “System
Setup”.
- “PRESET parameter function table” in the section of “PRESET
Parameter Setting”.
- the menu of “Open/Short Detection Mode (OS)” in the section of
“PROGRAM Parameter Setting”.
- “Test Steps (OS) Standby Menu” & “Description Table for Test
Result” in the section of “How to Perform Tests”.
- “CONFIRM Window” in the section of “Change User Password”.
- the description in the section of “Command Description”.
Add the descriptions of “RS-232 interface”.
Add two new items in the section of “Solving Problems”.
Modify “Material Contents Declaration”.
Add the section of “Timing Diagram”.
Add the related description of “IR Range Selection”.
- “CE Declaration”.
− Figure 2-4 in the section of “Remote Control”.
- description of “Time T2” in the section of “Timing Diagram”.
Modify the figure of item (2) in the section of “DCA Calibration (DC/IR
MODE)”.
Add Standard warnings to the section of “Solving Problems”.
Add the warning to the section of “The Danger of Operating”.
Modify “CE Declaration of Conformity”.
Modify the following:
− Rear panel figure in the section of “Rear Panel”.