Operation and Setting
2-17
2.5 Other User Setting Function
2.5.1 KEY LOCK Function
■ Setting KEY LOCK
In [Standby Menu], you can enable KEY LOCK function if LOCK is not highlighted.
(1) Press Function Key [MENU], use Function Key [F1] and [F2] to move the highlight to
“KEY LOCK”, and press Function Key [SELECT] to enter into the KEY LOCK setting
menu.
A
B
ENTER
RETURN
(2) Use Function Key [A] and [B] to input the PASSWORD (default is AAAA.)
(3) Press Function Key [ENTER] will prompt a selection window is highlighted.
YES
NO
CANCEL
(4) You can press Function Key [YES] or [NO] to select if lock the MEMORY RECALL
function as well. Exit the menu after completing KEY LOCK function and LOCK is
highlighted in the meantime.
(5) Press Function Key [CANCEL] to cancel the action and exit the set menu.
■ Canceling KEY LOCK
In [Standby Menu], you can release KEY LOCK if LOCK is highlighted. Follow the steps
above to cancel KEY LOCK, and LOCK will not be highlighted.
2.5.2 Auto Range
(1) Set WV-AUTO RANGE as ON under PRESET function list.
(2) The current set to high range as below shown.
To Next Page
Loading...
Need help?
General
