Chroma 19073 - System Setup

Operation and Setting
2-7
LAST
1. (0 STEPS)
2. (0 STEPS)
DOWN
3. (0 STEPS)
4. (0 STEPS)
SELECT
5. (0 STEPS)
RETURN
SEL. MEMORY
RMT
LOCK
OFST
ERR
(4) At this time use Function Key [F1] and [F2] to move the highlight to the memory for
processing, then press Function Key [F3] will prompt a confirmation window. Press
Function Key [ENTER] to confirm and Function Key [UP] or [DOWN] to select stored
character of file name. Press [NEXT.C] to select next character and [ENTER] to
confirm the file name, the maximum file name is 10 characters.
UP
1. (2 STEPS)HIPOT
2. (0 STEPS)
DOWN
3. (0 STEPS)
4. (0 STEPS)
ENTER
5. (0 STEPS)
CANCEL
SEL. MEMORY
RMT
LOCK
OFST
ERR
(5) When executing [RECALL] or [DELETE] function, use Function Key [F1] and [F2] to
move the highlight to the memory for processing, then press Function Key [F3] will
prompt a confirmation window. Press Function Key [YES] to confirm or Function Key
[NO] to cancel, then can recall or delete the memory set. Each memory contains
test parameters, preset parameters and number of test steps.
LAST
1. (2 STEPS)HIPOT
2. (0 STEPS)
DOWN
3. (0 STEPS)
4. (0 STEPS)
SELECT
5. (0 STEPS)
RETURN
SEL. MEMORY
RMT
LOCK
OFST
ERR
2.3.2 System Setup
■ How to enter the SYSTEM SETUP menu
(1) In [Standby Menu], press the Function Key [MENU] and by using Function Key [F1],
[F2] to move the highlight to “SYSTEM” and then press Function Key [F3] to enter
into the parameter setting menu as below: