Chroma 3302 - Page 69

Application of Interface
5-3
b. START(TRIG.) : The trigger model of test indicative light.
AUTO : Automatic trigger model, when set parameter and set test differ time it
means automatic trigger model, so this light will light when start to
test.
MANUAL : Manual trigger model, when set parameter and no set test differ time,
it means manual trigger model, so this light will light when start to
test.
c. NO-GOOD : Indicate the item of no-good
Lx : Inductance no-good, in the procedure of test, the inductance
measurement is over or under then judge no-good, this light will light.
Lk : Leakage no-good, in the procedure of test, the leakage inductance
measurement is over or under then judge no-good, this light will light.
TURN : Turn-ratio and phase no-good, in the procedure of test, the turn-ratio
measurement is over or under then judge no-good, this light will light.
DCR : DCR no good, in the procedure of test, the DCR measurement is over
or under then judge no-good, this light will light.
Cx : The capacity of transformer no-good, in the procedure of test, the
capacity measurement is over or under then judge no-good, this light
will light.
PS : Pin short, in the procedure of test, if there is any short is tested then
the judge no-good, this light will light.
BL : Balance no-good, in the procedure of balance test, if there is any over
high limit the judge no-good, this light will light.
d. CONTROL : Control area
START : Trigger control key, when press this key then operate the test acting.
RESET : Reset the trigger control key, when press this key then stop all the test
to return original preparing test condition.