Need help?Do you have a question about the Chroma 3302 and is the answer not in the manual?
General| Brand | Chroma |
|---|---|
| Model | 3302 |
| Category | Test Equipment |
| Language | English |
Lists measurable parameters: Impedance (|Z|, |Y|), Inductance (L), Capacitance (C), Resistance (R), etc.
Specifies the operational ranges for parameters like |Z|, R, X, |Y|, C, L, D, Q, θ, DCR, Np/Ns, Vs.
Details conditions for accuracy specification: warm-up time, OPEN/SHORT corrections, and calibration.
Provides specific accuracy data: within 1 year calibration, temperature, humidity, warm-up, and zero calibration.
Explains zero open, zero short, and load correction methods for eliminating measurement errors and improving accuracy.
Instructions for safely connecting the instrument to the power source, ensuring correct voltage and frequency.
Explains clear/help, OPT/LOCK, ENTER, RESET, POWER switch, and memory card slot functions for operation.
Explains interface slots: Scan, Handler, Printer, RS-232, and DCA control interfaces and their functions.
Details settings: Average Time, Hard Copy, Shift Pos, Parameter Z, Link 1320, and Special TR.
Step-by-step guide for performing an open circuit test on transformers.
Step-by-step instructions for executing a short circuit test on transformers.
Guides the user through setting up and performing a test on a single transformer.
Explains scan box operation, connecting test fixtures, and starting automated transformer testing.
Guides entering LCRZ Parameter Analysis mode for transformer component testing and detailed analysis.
Details configuring and performing Multi-frequency Scan Tests (LIST SWEEP) for comprehensive analysis.
Details controls and indicators on the 3001A scan box front panel: RESULT (GOOD/NO GOOD), START/TRIG, NO-GOOD items, CONTROL.
Explains rear panel terminals: TEST CABLE INPUT, SCAN I/F, and POWER CORD (AC 120V) connections.
Guides input of TRANSFORMER ID, PRIMARY, SECONDARY, AUTO-TEST TIME, and RETEST NUMBER for scan testing.
Explains how to connect the handler interface and the signal characteristics for external control.
To Next Page
