NOTE:
• If snow, ice, mud, or any foreign substance builds up on the camera lenses, clean the lenses,
rinse with water, and dry with a soft cloth. Do not cover the lenses.
• If a malfunction with the system has occurred, see your nearest authorized dealer.
WARNING!
Drivers must be careful when backing up even when using the Surround View Camera. Always
check carefully behind your vehicle, and be sure to check for pedestrians, animals, other
vehicles, obstructions, or blind spots before backing up. You are responsible for the safety of
your surroundings and must continue to pay attention while backing up. Failure to do so can
result in serious injury or death.
CAUTION!
• To avoid vehicle damage, Surround View should only be used as a parking aid. The
Surround View camera is unable to view every obstacle or object in your drive path.
• To avoid vehicle damage, the vehicle must be driven slowly when using Surround View to be
able to stop in time when an obstacle is seen. It is recommended that the driver look
frequently over his/her shoulder when using Surround View.
BLIND SPOT MONITORING
The Blind Spot Monitoring (BSM) system uses two radar-based sensors located inside the rear
bumper fascia to detect Highway licensable vehicles (automobiles, trucks, motorcycles etc.) that
enter the blind spot zones from the rear/front/side of the vehicle.
The BSM detection zone covers approximately one lane width on both sides of the vehicle 12 ft
(3.8 m). The zone length starts at the outside rear view mirror and extends approximately 10 ft
(3 m) beyond the rear bumper of the vehicle. The BSM system monitors the detection zones on
both sides of the vehicle when the vehicle speed reaches approximately 6 mph (10 km/h) or
higher, and will alert the driver of vehicles in these areas.
When the vehicle is started, the BSM warning light will momentarily illuminate in both outside
rear view mirrors to let the driver know that the system is operational. The BSM system sensors
operate when the vehicle is in any forward gear or REVERSE and enters stand by mode when the
vehicle is in PARK.
The BSM warning light, located in the outside mirrors, will illuminate if a vehicle moves into a
blind spot zone.
The BSM system can also be configured to sound an audible (chime) alert and mute the radio to
notify you of objects that have entered the detection zones.
OPERATING YOUR VEHICLE
119
To Next Page
