• Unless reset, this message will continue to display each time the ignition is cycled to the
ON/RUN position.
• To reset the oil change indicator after performing the scheduled maintenance, refer to the
following procedure.
Without pressing the brake pedal, push the
ENGINE START/STOP button and place the
ignition in the ON/RUN position (do not start
the vehicle.)
1. Push the OK button to enter the instrument
cluster display menu screen.
2. Push and release the down arrow button to
access the ”Oil Life” menu screen.
3. Push the left arrow button or right arrow
button to access the “Vehicle Info” sub-
menu.
4. Hold the OK button to reset the “Oil Life”
to 100%.
5. Push the up arrow button to exit the instru-
ment cluster display menu screen.
NOTE:
If the indicator message illuminates when you start the vehicle, the oil change indicator system did
not reset. If necessary, repeat this procedure.
IF YOUR ENGINE OVERHEATS
In any of the following situations, you can reduce the potential for overheating by taking the
appropriate action.
• On the highways — slow down.
• In cit y traffic — while stopped, place the transmission in NEUTRAL, but do not increase engine
idle speed.
NOTE:
There are steps that you can take to slow down an impending overheat condition:
• If your air conditioner (A/C) is on, turn it off. The A/C system adds heat to the engine cooling
system and turning the A/C off can help remove this heat.
• You can also turn the temperature control to maximum heat, the mode control to floor and the
blower control to high. This allows the heater core to act as a supplement to the radiator and
aids in removing heat from the engine cooling system.
Keyless Push Button Ignition
WHAT TO DO IN EMERGENCIES
230
To Next Page
Loading...
