Instrument Cluster Indicator Lights
– Turn Signal Indicator
The arrows will flash with the exterior turn signals when the turn signal lever is operated. A tone
will chime, and a message will appear if either turn signal is left on for more than 1 mile (1.6 km).
NOTE:
If either indicator flashes at a rapid rate, check for a defective outside light bulb.
– Front Fog Light Indicator
This indicator will illuminate when the front fog lights are on.
– Park/Headlight ON Indicator
This indicator will illuminate when the park lights or headlights are turned on.
– High Beam Indicator
Indicates that headlights are on high beam.
— Vehicle Security Light
Indicates that the vehicle security system is armed.
– Low Windshield Washer Fluid Indicator — If Equipped
This indicator will illuminate when the windshield washer fluid is low.
– Forward Collision Warning (FCW) OFF Indicator
NOTE:
• The default status of FCW is “On.” This allows the system to warn you of a possible collision
with the vehicle in front of you.
• The forward collision button is located in the Uconnect display.
To turn the FCW system OFF, push the forward collision button once to turn the system OFF
(telltale will illuminate in the cluster).
Refer to “Forward Collision Warning (FCW)” in “Operating Your Vehicle” for further informa-
tion.
– Service Forward Collision Warning (FCW) System Indicator Light
This telltale will turn on to indicate that the Forward Collision Warning (FCW) system is not
functioning properly and service is required. Contact your authorized dealer for service.
– KeySense Indicator Light
This indicator will illuminate when a KeySense key fob is detected upon startup of the vehicle.
While the KeySense key is in use, the vehicle will respond to customized vehicle settings and
mandatory settings which were specified when the KeySense key was activated and given a PIN.
WHAT TO DO IN EMERGENCIES
227
To Next Page
