Here’s How:
1. Push the Uconnect Phone button
and wait for the beep, then say “reply.” Uconnect will
give the following prompt: “Please say the message you would like to send.”
2. Wait for the beep and say one of the pre-defined messages. (If you are not sure, you can say
“help”). Uconnect will then read the pre-defined messages allowed.
3. As soon as you hear the message you would like to send, you can interrupt the list of prompts
by pushing the Uconnect phone button and saying the phrase. Uconnect will confirm the
message by reading it back to you.
4. Push the Phone button and say “Send.”
PRE-DEFINED VOICE TEXT REPLY RESPONSES
Yes. Stuck in Traffic. See you later.
No. Start without me. I’ll be Late.
Okay. Where are you?
I will be <5, 10, 15,...etc.>
minutes late.
Call me. Are you there yet?
I’ll call you later. I need directions.
See you in <5, 10, 15,...etc.>
of minutes.
I’m on my way.
Can’t talk right now.
I’m lost. Thanks.
NOTE:
To make the SMS voice reading function available, the SMS notification option on phone must
be enabled; this option is usually available on the phone, in the Bluetooth connections menu for
a device registered as Uconnect. After enabling this function on the mobile phone, it must be
disconnected and reconnected with the Uconnect system in order to make it effective.
Helpful Tips And Common Questions To Improve Bluetooth
Performance With Your Uconnect System
Mobile Phone won’t reconnect to system after pairing:
• Set mobile phone to auto-connect or trusted device in mobile phone Bluetooth settings
(Blackberry devices).
• Perform a factory reset on your mobile phone. Refer to your mobile phone manufacturer or
cellular provider for instructions.
• Many mobile phones do not automatically reconnect after being restarted (hard reboot). Your
mobile phone can still be connected manually. Close all applications that may be operating
(refer to mobile phone manufacturer’s instructions), and follow “Pairing (Wirelessly Connect-
ing) Your Mobile Phone To The Uconnect System”.
Mobile Phone won’t pair to system:
• Perform a hard reset in the mobile phone by removing the battery (if removable — see your
mobile phone’s owner manual).
• Delete pairing history in mobile phone and Uconnect system; usually found in phone’s
Bluetooth connection settings.
ELECTRONICS
189
To Next Page
Loading...
