3. Twist the release knob counterclockwise and pull the bin towards you.
4. Remove the filter and dump the debris in a
trash can. Lightly tap the filter on the collec-
tion bin to remove loose debris from the
filter. If the filter is clogged from extended
use, have the filter replaced by your autho-
rized dealer.
5. Reverse the procedure to reinstall.
NOTE:
The debris bin must be fully installed and
locked for the vacuum to function properly.
Hose Access Port
The hose access port is located behind the
upper access panel behind the third row seat on
the driver’s side.
To Remove Vacuum Hose For Cleaning
1. Unclip the hose from the hose access port located in the rear of the vehicle by pushing the
yellow vacuum hose release lever with right thumb and lifting the hose with index finger.
2. Return to vacuum nozzle storage location
located behind the sliding door.
3. Grab the vacuum nozzle and gently pull the
hose out through vacuum nozzle storage
location.
4. Shake the hose to remove any objects stuck
in the hose. Take care not to perforate the
hose while attempting to dislodge any ob-
jects.
5. Reverse the procedure to reinstall and clip
the hose into place.
Debris Bin Release Knob
Vacuum Hose Release Lever
UTILITY
218
To Next Page
