To Unstow Second Row Seats
For Manual Seats: To unstow the seat from the floor, move the front seat all the way forward
using the manual seat adjustment bar.
For Power Seats: Push the Stow ‘n Go Assist button located on the B pillar trim (if equipped).
Refer to "Stow 'n Go Assist - If Equipped" in this section for instructions.
1. To access the storage bin, place the lock rod in the locked position.
NOTE:
• Push the lock rod inward for the locked position.
• Pull outward on the lock rod for the unlocked position.
2. Pull the latch located near the second row seat to open the floor panel.
3. Pull the floor panel and position it toward the front seats while folding the top half down and
rest it against the front seats.
4. Pull the strap located on the seat and pull the seat out of the storage bin. Push the seat
rearward making sure that it locks into the floor. Fold the seatback into the upright position
and pull the headrest up.
NOTE:
The seatback may be locked, if it is, it will be necessary to use the recliner handle to unlock the
back before folding into the upright position.
5. To position the floor panel back into its original state, grab the bottom corner and extend it
outward.
6. Lay the floor panel flat and push down until it clicks into position. Replace the floor mat as
needed.
7. Readjust the front seat as needed.
Refer to “Stow ‘n Go” in “Getting to Know Your Vehicle” in the Owner’s Manual on
www.chrysler.com/
en/owners/manuals for additional information.
WARNING!
• In a collision, you or others in your vehicle could be injured if seats are not properly latched
to their floor attachments. Always be sure the seats are fully latched.
• Sitting in a seat with the head restraint in its lowered position could result in serious injury or
death in a collision. Always make sure the head restraints are in their upright positions when
the seat is to be occupied.
GETTING STARTED
82
To Next Page
Loading...
