Chrysler PACIFICA 2017 - Page 93

Automatic Headlights
This system automatically turns your headlights on or off based on ambient light levels. To turn
the system on, turn the headlight switch to the extreme clockwise position aligning the indicator
with the AUTO on the headlight switch. When the system is on, the Headlight Time Delay
feature is also on. This means your headlights will stay on for up to 90 seconds after you turn the
ignition switch OFF. To turn the Automatic System off, turn the headlight switch counterclock-
wise to the O (off) position.
NOTE:
The engine must be running before the headlights will come on in the Automatic mode.
Automatic High Beam — If Equipped
The Automatic High Beam system provides increased forward lighting at night by automating
high beam control through the use of a digital camera mounted on the windshield. This camera
detects vehicle specific light and automatically switches from high beams to low beams until the
approaching vehicle is out of view.
NOTE:
Broken, muddy, or obstructed headlights and taillights of vehicles in the field of view will cause
headlights to remain on longer (closer to the vehicle). Also, dirt, film and other obstructions on
the windshield or camera lens will cause the system to function improperly.
To Activate
1. Select “Automatic High Beams — ON” through the Uconnect system. Refer to "Uconnect
Settings” in “Multimedia” in your Owner’s Manual on www.chrysler.com/en/owners/manuals
for further information.
2. Rotate the headlight switch clockwise to the AUTO position.
3. Push the multifunction lever away from you to switch the headlights to the high beam position.
Refer to “Multifunction Lever” in this section for further information.
NOTE:
This system will not activate until the vehicle is at, or above 16 mph (25 km/h).
To Deactivate
Perform either of the following steps to deactivate the Automatic High Beam system.
1. Select “Automatic High Beams — OFF” through the Uconnect System. Refer to “Uconnect
Settings” in “Multimedia” in your Owner’s Manual on www.chrysler.com/en/owners/manuals
for further information.
2. Pull the multifunction lever toward you to switch the headlights from the high beam to the low
beam position.
3. Rotate the headlight switch counterclockwise from the AUTO to the on position.
NOTE:
Once active, the Automatic High Beam system will stop functioning below 12 mph (20 km/h).
OPERATING YOUR VEHICLE
91