OPERATING INSTRUCTIONS
53
ATTACHING GLOVES (GLOVE PORT OPTION)
Procedure:
1. Slide the left hand glove into the left port. Leave approximately 3” (8cm) of the glove outside the port.
2. Pull the end of the glove over the port, all the way to the port collar.
3. Secure the glove with a 6” (15.25 cm) worm clamp. Over-tightening can cause clamp to cut rubber glove.
4. Repeat all steps for right glove.
Note: CSZ is continuously upgrading the components used in its equipment. Consequently,
the physical appearance of certain components may vary from that shown.
To Next Page
Loading...
