09.01.q. tuning motors
09.01.r. programming
product flux
09.01.s. product audit
09.01.r. id.machine
09.02. “data”
09.03. “free”
09.04. “clean”
with respect to the setup in 09.01.a:
- only in the I machines, the rotation speed of the boiler pumps
can be changed (keys “4” and “5”) by +/- 30 %; the change
concerns all the activations of the pumps for all selections;
-
the rotation time of every single product motor can be changed
(key “4” and “5”) by +/- 30% compared to the time set in the
recipe variables (see 09.01.a.); the change concerns all the
activations of the product motors for all selections;
- only in the E machines. the time required to start the grinder
motor can be tuned by +/- 30%, with respect to the setup of
very single selection; once established, this increase or decrease
is active for each activation;
the quantity in product grams dispensed for each operation second
of the motor can be set up for each container (keys “4” and “5”);
to display the partial and total product quantity dispensed; the
partial audit of each counter is reset by displaying it and holding
key 4 down for some seconds;
identification codes to detect the EVA DTS data
- machine number;
- location number;
- machine configuration;
- address for connection with the DDCMP protocol;
- 0 to enable the EVA DTS acquisition; 1 for the audit via
telemetry (option); 2 to disable the acquisition;
choose the option “data” to enable the display to show the data of
the dispensing cycles you have performed in succession, just as in
09.01.h.;
to dispense selections on a free basis; the selections made in this
mode are counted separately (09.01.h.);
choose this option and press “1”, “2” or “3” to enable the vending
machine to dispense a pre-fixed water quantity to wash the
corresponding circuit (see 08.03.);
the display shows:
in the E machines, a special wash cycle is intended to sanitise the
coffee brewer by using specific cleaning products in tabs; access
the programming mode when the door is open and the machine on
(use the service key); after having chosen “4” and pressed “8”, the
display shows:
attention
the vending machine is supplied and running to all effects; the
mobile parts of the coffee brewer will be handled; act extremely
carefully;
after having positioned the cup beneath the dispensing nozzles, put
a tab in the coffee brewer chamber; press “1” and wait for the
wash cycle to automatically come to an end;
codice ID 101
00
codice ID 104
00
codice ID 106
00
indirizzo VIDTS
00
TEST VEND
cleaning
sel. 1-2-3 8=hc
cleaning N
Heath cleaning
Brewer P1=START
Data Audit 0=EvaD
1=TLM 2=off 00
product N
gr./sec. 0.0
dispensed qty N
Tot. Gr. 00
dispensed qty N
Part. Gr. 00
tuning grinder N
percent +00 %
tuning motor N
percent +00 %
cino eC by
MAN1010105 rel. 03 dated 12.02.2014 page no. 36 of 50 page
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: rheavendors@rheavendors.com
rheavendors group's sole property
tuning pump N
percent +00 %
To Next Page
Loading...
