Cino eC - Yearly; Out of Order

L
M
12.03. yearly
dispensing system
products canister
powder aspirator drawer
silicone tubes
boiler
in E machines
coffee brewer
pressure boiler
12.04. out of order
temporary
definitive
replace the gasket at the base of the mixing bowl of the mixer;
remove the mixer motor fan by pulling it; replace the gasket of the
mixer motor shaft “I”;
disassemble the products canister from the machine; empty them,
disassemble them in their basic components and wash them
carefully “L”;
disassemble the mixing bowls; pull out the extraction drawers “M”;
wash them with plenty of lukewarm water;
make sure that the water transport tubes are intact and that they
have kept their transparency, replace them, if necessary;
empty the boiler by means of a drain pipe; extract it from the
machine, remove the cover and wash the tank by removing any
solid residue that may have built up at the bottom;
remove any calcareous deposit from active elements: temperature
probe, heating element, level probes, the shafts of rotary
pumps, …;
- replace the upper and lower pistons gasket;
- replace upper and lower filters;
- check the status of the brewing chamber;
disassemble the pressure boiler; separate the pressure boiler from
the solenoid valves block and check the seal o-ring
; clean the
instant and espresso outlet water circuits; check the third way of
the espresso valve drain by removing any trace of residue; empty
and clean the air break tank;
if the vending machine should be inactive for a long period, please
act as follows:
- in E machines, perform the uninstall cycle (see 09.01.f.);
- in I machines, set the boiler water temperature to zero;
- detach the water and energy supply;
- in I machines, empty the boiler;
- empty the liquid waste tray and the internal water tank;
- empty and clean the product canisters;
- clean the internal and external surfaces by using a wet piece of
cloth;
- cover the machine by means of a cloth;
- store it in a sheltered place, at a temperature not below 5 °C, at
a relative humidity not above 80%;
if you should definitively set the vending machine out of
commission and provide for the disposal of some parts thereof,
after having carried out the operations above, disassemble the
vending machine by separating every single component and
subdividing the parts according to the nature of materials; the
applied symbol means that the components of the vending machine
shall be not processed as home rubbish, but delivered to the
collection points capable of recycling electric and electronic
equipment; refer to the 2002/96/EC Directive and to the relative
rules;
the complete text of the European directive about this specific
subject-matter is made available on the Internet site:
http://eur-lex.europa.eu/
directive 2002/96/EC of 27/01/2003
I
cino eC by
MAN1010105 rel. 03 dated 12.02.2014 page no. 46 of 50 page
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: rheavendors@rheavendors.com
rheavendors group's sole property