EasyManua.ls Logo

Cino eC - Troubleshooting Error Codes; Communication and System Errors; Water Supply and Brewing Errors

Cino eC
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11.
solution of problems
error
OFF 2
OFF 3
OFF 5
OFF 6
o OFF 6A
OFF 6B
OFF 7
OFF 8A
OFF 8B
some malfunctions produce an error message on the display; some
general information is supplied here below for these messages;
actions/comments
check the connection between the machine and the payment
system; check the supply, programming (see 09.01.f.) and
operation of the payment system; it can display OFF 2 E
(executive) or OFF 2 M (mdb);
power off the machine and empty the drip tray (see 13.01.);
EAROM of the CPU board failed; replace the CPU board
(see 05.39.a.);
water inlet solenoid valve in safety status (waste water from the
boiler overflow) or non operating; the internal filter net clogged;
water not supplied by the network, water supply flow rate not
adequate; supply water circuit throttled or clogged; it may
physiologically occur at the first power on when the pressure boiler
that is completely empty will require more time than usual to fill;
(see 05.13.);
there is a control connecting water reloads with the drinks you
have dispensed; if some water reloads occur without dispensing
any drink, this will produce the 6B error; make sure there is no
leakage in the water circuit;
there is a maximum operation time of
the brewing pump, at the
expiry of which error 7 is produced; check the efficiency of the
water circuit: volumetric counter, pump, three-way solenoid valve,
…; brewing chamber as well as upper and lower filter of the coffee
brewer; the quantity and grinding degree of coffee shall cause the
machine to brew for about 10/15 seconds;
electrically and mechanically check the switch controlling the coffee
brewer rotation, the control cam, the brewer rotation motor and its
crank;
make sure that the coffee brewer has properly positioned (against
the support wall); check the operation of the micro switch operated
by the presence of the coffee brewer;
cause
no communication
between the machine
and the payment
system
drip tray full
no data storage
filling time for the
boiler or the air break
too long
water reloads without
dispensing any drink
espresso brewing time
too long
(E machines)
false position of the
coffee brewer
(E machines)
no coffee brewer
(E machines)
cino eC by
MAN1010105 rel. 03 dated 12.02.2014 page no. 42 of 50 page
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: rheavendors@rheavendors.com
rheavendors group's sole property

Related product manuals