CipherLab 1105 User Manual

15
Update
This chapter explains the features and usage of the barcode scanner.
IN THIS CHAPTER
1.1 Power ...................................................................... 15
1.2 LED Indicator ............................................................ 15
1.3 Beeper..................................................................... 16
1.4 Scan Modes .............................................................. 18
1.5 Scanning Timeout...................................................... 22
1.6 Delay between Re-read............................................... 23
1.7 Read Redundancy for All Symblogies ............................ 24
1.8 Auto-Sense Mode (1100 Only)..................................... 25
1.9 Negative Barcodes ..................................................... 25
1.1 POWER
Connect the interface cable between the scanner and your computer.
 If using the RS-232 cable, you must join the power supply cord to power up the
scanner.
 The scanner will respond with one long beep (high tone) and its LED indicator will
become solid red and go off quickly.
1.2 LED INDICATOR
The dual-color LED on top of the scanner is used to provide user feedback. For example,
the LED becomes solid red and goes off quickly upon powering on or reading a barcode
successfully. You may tell the difference by the beeps – you will hear a long beep when
powering on the scanner, and a short beep (pitch programmable) when it reads a
barcode successfully.
Scanner LED
Meaning
Red,
on-off
---
 Power on, with one long beep (high tone, LED on for 1 second)
 Good Read, with one short beep (high tone) and beeper pitch
programmable
--- Green,
solid
Configuration Mode
Chapter 1
UNDERSTANDING THE BARCODE SCANNER

CipherLab 1105 Specifications

General

Type	Handheld bar code reader
Wavelength	630 nm
Sensor type	Laser
Read rate (max)	100 reads/s
Pitch reading angle	-70 - 70 °
Optical sensor resolution	3648 pixels
Linear (1D) barcodes supported	Codabar, Code 128, Code 39, Code 93, GS1-128 (UCC/EAN-128), MSI, Pharmacode, Plessey, Telepen, U.P.C.
2D (matrix & stacked) barcodes supported	-
Connectivity technology	Wired
Product color	Gray
Housing material	Polyurethane
Power consumption (standby)	0.06 W
Power consumption (typical)	0.190 W
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	145 mm
Width	93 mm
Height	64 mm
Weight	165 g