21
Update
Chapter 1
Understanding the Barcode Scanner
1.4.7 REPEAT MODE
Like the Continuous Mode, the scanner is always scanning. But now the scan trigger acts
like a “re-transmission” button when being pressed within one second after a successful
reading, which will re-transmit the same data without actually reading the barcode again.
This scan mode is most useful when the same barcode is to be read many times.
Capable of re-transmitting barcode data if triggering within one second after a
successful decoding.
Such re-transmission can be activated as many times as needed, as long as the time
interval between each triggering does not exceed one second.
Repeat Mode
1.4.8 MOMENTARY MODE
The scanner will be scanning as long as the trigger is hold down.
The scanning won't stop until you release the trigger.
Momentary Mode
To Next Page
Loading...
