CipherLab 1105

20
Enter Setup
1000/1090+/1100/1105 Barcode Scanner User Guide
1.4.4 AUTO OFF MODE
The scanner will start scanning once the trigger is pressed.
 The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout
expires.
Note: Refer to “Scanning Timeout”.
Auto Off Mode
Note: By default, the scan mode of 1000 and 1090+ is set to Auto Off mode.
1.4.5 AUTO POWER OFF MODE
The scanner will start scanning once the trigger is pressed.
 The scanning won't stop until the pre-set timeout expires, and, the pre-set timeout
period re-counts after each successful decoding.
Note: Refer to “Delay between Re-read” and “Scanning Timeout”.
Auto Power Off Mode
1.4.6 ALTERNATE MODE
The scanner will start scanning once the trigger is pressed
 The scanning won't stop until you press the trigger again.
Alternate Mode