CipherLab 1105 User Manual

22
Enter Setup
1000/1090+/1100/1105 Barcode Scanner User Guide
1.5 SCANNING TIMEOUT
Specify the scanning time interval (1~255 sec.; 0= Disable) when the scan mode is set
to any of the following –
 Laser mode
 Auto Off mode
 Auto Power Off mode
Scanner Time-out
after 0~255 sec.
(*10)
1) Read the barcode above to specify the time interval before the scan engine times out.
2) Read the “
Decimal Value” barcode on page 127. For example, read “1” and “5” for the
scanner to automatically shut down after being idle for 15 seconds.
3) Read the “Validate” barcode on the same page to complete this setting.

CipherLab 1105 Specifications

General

Type	Handheld bar code reader
Wavelength	630 nm
Sensor type	Laser
Read rate (max)	100 reads/s
Pitch reading angle	-70 - 70 °
Optical sensor resolution	3648 pixels
Linear (1D) barcodes supported	Codabar, Code 128, Code 39, Code 93, GS1-128 (UCC/EAN-128), MSI, Pharmacode, Plessey, Telepen, U.P.C.
2D (matrix & stacked) barcodes supported	-
Connectivity technology	Wired
Product color	Gray
Housing material	Polyurethane
Power consumption (standby)	0.06 W
Power consumption (typical)	0.190 W
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	145 mm
Width	93 mm
Height	64 mm
Weight	165 g