1.09 Nov. 25, 2009
Modified: 2.2.2 Baud Rate — change setup barcode for 4800 bps
(change 100079 to 100100)
1.08 Oct. 30, 2009
Modified: 1.10 Auto-Sense Mode (1500 Only) — Continuous mode as
an alternative
Modified: 1.12 Symbologies Supported —
ISBT 128 enabled by
default
Modified: 2.2.2 Baud Rate — add setup barcode for 4800 bps
Modified: 4.2.2 Symbologies for Character Substitution (All 3
Sets) — add ISBT 128
Modified: 4.4.1 Select Pre-defined Code ID — add ISBT 128
Modified: 4.4.2 Change Code ID — add ISBT 128
Modified: 4.5 Length Code — add ISBT 128
Modified: 5.3.1 Applicable Code Type (for Editing Format) —
add
ISBT 128
1.07 June 03, 2009
Modified: 1.3 LED Indicator — Power on LED (1 s)
Modified: 1.4 Beeper — More barcodes required for Multi-Barcode
Editor
Modified: 3.12.3 Code Length Qualification — MSI must include
checksum
Modified: 4.6.2 Activate the Concatenation of Barcodes —
add
description of LED and beeper
Modified: 4.7 Removal of Special Character
Modified: Appendix I Firmware Upgrade
Modified: Appendix II Host Serial Commands
1.06 Mar. 02, 2009
Modified: 3.10 GS1-128 (EAN-128)
Modified: 3.16 GS1 DataBar (RSS Family)
Modified: 3.16.2 GS1 DataBar Omnidirectional (RSS-14)
Modified: 3.16.3 GS1 DataBar Expanded (RSS Expanded)
Modified: 3.16.4 GS1 DataBar Limited (RSS Limited)
1.05 Feb. 11, 2009
Modified: 1.6 Scan Modes — add Alternate Mode to table
New: 1.6.8 Alternate Mode — add setup barcode (100203)
Modified: 1.8 Delay between Re-read — add Alternate Mode
1.04 Dec. 12, 2008
Modified: 4.6 Multi-Barcode Editor — 4-digit length excludes prefix,
suffix, length code, etc.
Modified: 5.2.3 Define Data Criteria — Data length includes
prefix,
suffix, length code, etc.
1.03 Nov. 24, 2008
New: Quick Start — Flowchart
New: 1.3.2 Good Read LED Duration
Modified: 4.6 Multi-Barcode Editor — Reset scan mode to “Laser”
Modified: Host Serial Commands — adds D, E commands
1.02 Sep. 11, 2008
Modified: section 1.10 Auto-Sense Mode — add setup barcodes for
improving sensitivity
1.01 July 23, 2008
Modified: section 1.2 Transmit Buffer — the use of transmit buffer is
different from memory mode, and the latter is not supported by
1500 scanner!
1.00 May 26, 2008 Initial release
To Next Page
Loading...
Need help?
General
