CipherLab 8200 User Manual

222
CipherLab BASIC Programming Part I
The aiming dot will not go off until it times out or you press the trigger key again to
start scanning. Index #145 is used for timeout duration, if necessary.
COMPARISON TABLE
Scan Mode
Start to Scan
Stop Scanning
Always Press
trigger
once
Hold
trigger
Press
trigger
twice
Release
trigger
Press
trigger
once
Barcode
being
read
Timeout
Continuous mode

Test mode

Repeat mode

Momentary mode
 
Alternate mode
 
Aiming mode
  
Laser mode
   
Auto Off mode
  
Auto Power Off
mode
 
Continuous Mode
Non-stop scanning
 To decode t
he same barcode repeatedly, move away the scan beam and target it at the
barcode for each scanning.
Test Mode
Non-stop scanning (for testing purpose)
 Capable of decoding the same barcode repeatedly.
Repeat Mode
Non-stop scanning
 Capable of re-transmitt
ing barcode data if triggering within one second after a successful
decoding.
 Such re-transmission can be activated as many times as needed, as long as the time interval
between each triggering does not exceed one second.
Momentary Mode
Hold down the scan trigger to start with scanning.
 The scanning won't stop until you release the trigger.
Alternate Mode
Press the scan trigger to start with scanning.
 The scanning won't stop until you press the trigger again.

CipherLab 8200 Specifications

General

IP Rating	IP54
Display Type	LCD
Barcode Scanner	Laser
Connectivity	RS-232
I/O Ports	RS-232