CipherLab 8300 Reference Manual

10
8300 Series Mobile Computer Reference Manual
It takes at least twenty-four hours to fully charge the backup battery. However, it is
not necessary to fully charge the backup battery for the mobile computer to work.
 Monitor voltage level (see section 3.5 Power)
1.1.1 INSERTING THE BATTERY
For shipping and storage purposes, save the mobile computer and the main battery in
separate packages. This will keep both batteries in good condition for future use.
Note: Any improper handling may reduce the battery life.
1) Hold the mobile computer face down in one hand as shown below.
2) Release the battery lid latches on both sides of the battery compartment.
3) Remove the battery lid by the other hand.
4) Slide the battery pack into the battery compartment at a proper angle (30°~45°) so
that the contacts of the battery are pressed onto the protruding contacts inside the
compartment. Make sure that the battery is snugly fit into the compartment.
5) Replace the battery lid and lock it firmly.
Note: For a new battery, make sure it is fully charged before use. Always prepare a
spare battery pack, especially when you are on the road.
Figure 4: Installing the Main Battery

CipherLab 8300 Specifications

General

Brand	CipherLab
Model	8300
Category	PDA
Language	English