CipherLab 8300 Reference Manual

63
Chapter 3 System Menu
3.10.3 WLAN SETTING
Wireless networking can operate in two modes – (1) Ad-hoc mode: peer-to-peer, and (2)
Infrastructure mode: point to multi-point through access points.
Set the following parameters.
Local Name
Enter a name for identifying the mobile computer.
 By default, it is made up of model No. and the serial number.
SS ID
This refers to Service Set ID or Identifier.
 The mobile computer can ONLY communicate with access points that have the same SS ID.
System Scale
This refers to Access Point Density.
Options - [1] Low [2] Medium [3] High
 The value you set must match that set for the access point.
 “Low / Medium / High” means the mobile computer will search for other APs only when data
transmission rate is below “1 / 2 / 5” Mbps individually.
Power Saving
This refers to the low power consumption mode.
Options - Enable or Disable
 The value you set must match that set for the access point.
Preamble
Options - [1] Long [2] Short [3] Both
 The value you set must match that set for the access point.
Ad-Hoc
This refers to peer-to-peer mode, without going through access points.
Options - Enable or Disable

CipherLab 8300 Specifications

General

Brand	CipherLab
Model	8300
Category	PDA
Language	English