This laser component emits FDA / IEC Class 2 laser light at the exit
port. Do NOT STARE INTO BEAM DIRECTLY.
Do not aim the beam at the eyes.
Any adjustments or performance excluding those specified herein
may result in hazardous laser light exposure.
ENVIRONMENT
Operate the mobile computer at ambient temperatures from -20 to 50 and with
humidity range from 10% to 90%.
Store the device at ambient temperatures from -30 to 70 and with humidity range
from 5% to 95%.
Charge the device at ambient temperatures from 0 to 40 .
This device is built with a dust-proof and splash-proof structure that conforms to
protection class IP65/ IP67.
SPECIFIC ABSORPTION RATE (SAR) INFORMATION
USA
This device meets the government’s requirements for exposure to radio waves. This
device is designed and manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal Communications Commission of the U.S.
Government.
The exposure standard employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are
conducted using standard operating positions accepted by the FCC with the EUT
transmitting at the specified power level in different channels.
The FCC has granted an Equipment Authorization for this device with all reported SAR
levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information
on this device is on file with the FCC and can be found under the Display Grant section
of www.fcc.gov/eot/ea/fccid after searching on FCC ID: Q3N-RS35
Canada
The radiated output power of the Wireless Device is below the Innovation, Science and
Economic Development Canada (ISED) radio frequency exposure limits. The Wireless
Device should be used in such a manner such that the potential for human contact
during normal operation is minimized.
To Next Page
Loading...
Need help?
General
