CipherLab RS36 User Manual

47
4 Settings
1. SSH connection is used for port forwarding, and your user
account on the server is not allowed to run a shell.
2. SSH protocol version 2 is supported on host server.
Re-Key Every 60 Minutes In RFC 4253 (the SSH Transport Layer Protocol), the Re-Key
method ensures the key is exchanged only upon per gigabyte of
transmitted data or per hour of connection time, whichever occurs
sooner. Enable these options to trigger TE to exchange a new key
with the server every 60 minutes or following a total data flow of 1
Gigabyte in either direction.
Re-Key Every 1G of Traffic
Server
Environment Specify environment variables to be set on the SSH server.
Commands Represent a special command or subsystem to invoke on the SSH
server in lieu of an interactive shell. This is typically used for
non-interactive host sessions. For most users this will be blank.
TTY This setting can be used to add TTY Modes to be sent to the SSH
server.
Proxy
Type Proxy allows you to configure CL TE to use various types of proxy
servers in order to make network connections.
The settings affect the primary network connection from your CL TE
SSH session, but also any extra connections made as a result of
SSH port forwarding.
Tap to configure what type of proxy you want CL TE to use for its
network connections. The choices are:
- None: no proxy is used.
- SOCKS 4 or SOCKS 5: proxy through a SOCKS server.
- HTTP: proxy through a web server supporting the HTTP CONNECT
command.
The default setting is None.
Host Tap to specify the DNS name or IP address of the proxy server. The
default is blank.
Port Tap to specify the port on which the proxy server is listening. Set
this to match the port on the proxy server for connections.
User If your proxy server requires authentication, enter the username.
The default is blank.
Password If your proxy server requires authentication, enter the password.
The default is blank.

CipherLab RS36 Specifications

General

Brand	CipherLab
Model	RS36
Category	PDA
Language	English