Raption
108
Instruction Manual
8
The IP address assigned in the chapter 5, will be useful to connect with the Charge Point in
order to monitor the real-time status.
The main way to connect is using the PowerStudio client software supplied by CIRCUTOR,
and can also be downloaded in the download area of the CIRCUTOR website.
Note: Java software needs to be installed on your computer in order to run the client
software, please, download last version from: www.java.com
In remote connections, where is required communicate via 3G/4G
data with the Charge Point in order to monitor its parameters, it
should be noted that there will be a HIGH consumption of data.
In the case of doing the Charge Point monitoring, it is reccommended
to use Ethernet communications via internet (see chapter 4-D).
PowerStudio Client
To Next Page
Loading...
Need help?
General
