Raption
85Instruction Manual
OCPP 1.5
Go to the Setup Webpage → ‘Configuration’ tab → ‘Communications’ tab
Once in ‘General’ section, ‘Public IP source’ establishes where the Charge Point must
obtain the public IP address in order to send it later to the backend. Different values can
be selected:
B
Before starting
Check following steps in order to ensure the correct function of OCPP 1.5:
When done, please do not forget to save changes using ‘Save’ button in the upper right
part.
Choose the option selected under ‘Public IP source’ according to your network topology.
To Next Page
Loading...
