Raption
97Instruction Manual
OCPP 1.6
Before starting
B
Check following steps in order to ensure the correct function of OCPP 1.6:
Go to the Setup Webpage → ‘Integrations’ tab → ‘General’ tab
Once in ‘General’ section, Public IP source establishes where the Charge Point must obtain
the public IP address in order to send it later to the backend. Different values can be selected:
Choose the option selected under ‘Public IP source’ according to your network topology.
When done, please do not forget to save changes using ‘Apply’ button just below the option
selected.
To Next Page
Loading...
