Raption
72
Instruction Manual
4 — LOGGING IN
After you’re complete with the setting up as described in the section above, you are ready to
start logging into your router and start configuring it. This example shows how to connect
through Wi-Fi:
For cibersecurity reasons, modem’s WiFi connection is disabled by default.
In order to enable it, remember to adjust it in charger side, as explained in
section 4 E subsection C.
4.1.- Connect your ethernet cable in the LAN port and do all the settings being locally
connected (it can also be done from the WAN port when WAN port is configured as a LAN).
4.2.- At your service computer, look for access point named ChargePoint_xxxxxxxxxxxx
(where “x” means the MAC Address), and connect on it.
To Next Page
Loading...
